Personal Computer Plug-And-Go Scenario - NETGEAR WGE111 User Manual

Note: Follow the instructions in your PS2 or Xbox manual to configure the IP, DNS, and other
parameters of your game console. If you want to change the default IP address or configure the
WGE111 Wireless Game Adapter from a Web browser, see
Game Adapter Configuration" on page 3-6
Configuration Assistant" on page

Personal Computer Plug-and-Go Scenario

B
Figure 3-3: Personal Computer Scenario
What you need.
• Broadband Internet access through a router with an 802.11b or 802.11g wireless access point
(built in to the router or separate) without any security features enabled.
• A computer to run the initial configuration.
What you do.
Connect the Ethernet cable from your WGE111 Wireless Game Adapter (A) to the Ethernet
1.
port on your computer (B).
Make sure that the switch on the back of the WGE111 is set to the left side (labeled Internet),
2.
which corresponds to Infrastructure Mode.
Connect the power adapter to the WGE111 and verify the following:
3.
• The power light goes on.
• The Internet light is lit.
• The Ethernet light is lit.
Basic Setup
User Manual for the NETGEAR WGE111 Wireless Game Adapter
and "Using the NETGEAR Smart Wizard
3-9.
A
WGE111 Wireless Game Adapter
"Planning the WGE111 Wireless
3-5