Panasonic KX-TG1311AL Operating Instructions Manual page 21

TG1311_1312_1313E(e).book Page 21 Wednesday, June 4, 2008 4:10 PM
Liquid damage
Problem Cause/solution
Liquid or other form of L Disconnect the AC adaptor and
moisture has entered the telephone line cord from the base unit.
handset/base unit. Remove the batteries from the handset
and leave to dry for at least 3 days.
After the handset/base unit are
completely dry, reconnect the AC
adaptor and telephone line cord. Insert
the batteries and charge fully before
use. If the unit does not work properly,
contact your nearest Panasonic service
centre.
Caution:
L To avoid permanent damage, do not use a microwave oven to speed up
the drying process.
Registering the handset to the base unit
1
{j/OK}
2
{v}/{e}: "SETTING HS" i {>}
3
{v}/{e}: "REGISTRATION" i {>}
4
{v}/{e}: "REGISTER HS" i {>}
5
Press and hold {x} on the base unit for about 5 seconds.
L If all registered handsets start ringing, press {x} to stop, then start
again from step 1.
L The rest of the procedure must be completed within 4 minutes.
6
{v}/{e}: Select a base unit number. i {>}
7
Wait until "BS PIN" is displayed. i Enter the base unit PIN (default:
"0000"). i {>}
contact your nearest Panasonic service centre.
L If you forget your PIN,
L When the handset has been registered successfully, w stops
flashing.
L If w is still flashing, start again from step 1.
Useful Information
21