● . T he. switch. panel. does. not. stay. in. place. even. if. pushed. in.. Or. it. pops. out. with. every.
little.shock.
Possible.Cause.1.:.. T here.is.a.problem.with.adjustment.of.the.assembly..
Solution.1.: Refer to to 〔3〕 【D】 "Adjusting the Controller", and re-adjust the controller.
Possible.Cause.2.:.. T he.latch.is.broken..
Solution.1.: Refer to〔6〕 【A】 , and replace the latch.
【C】Problems with the Pedal
● The.pedal.does.not.work.for.the.electronic.sound.play..
Possible.Cause.1.:.. A .connector.may.be.disconnected.
Solution.1.: Check the connectors of sound source unit.
Solution.2.: Referring to 〔6〕 【B】 , open the sound source unit and check if all connectors
Possible.Cause.2.:.. T he.position.adjustment.of.the.pedal.sensor.may.be.incorrect..
Solution.1.: Refer to 〔3〕 【E】 "Adjusting the Pedal Sensor", and adjust the sensor.
Possible.Cause.3.:.. T he.pedal.sensor.may.be.faulty.
Solution.1.: Refer to 〔4〕 【B】 , and check if the pedal sensor is working properly.
Solution.2.: Replace the pedal sensor.
● The.pedal.effect.carries.on.for.electronic.sound.
Possible.Cause.1.:.. T he.position.adjustment.of.the.pedal.sensor.may.be.incorrect..
Solution.1.: Refer to 〔3〕 【E】 "Adjusting the Pedal Sensor", and adjust the sensor.
【D】Problems with emmitting Sounds
● No.acoustic.or.electronic.sound.comes.out.even.if.a.key.is.depressed..
Possible.Cause.1.:.. D oes.the.shank.stop.rail.stay.at.the.position.where.the.action.goes.in.and.out?.
Solution.1.: Refer to 〔3〕 【A】 , and set back the set lever.
Possible.Cause.2.:.. I f. the. demo. tune. is. playing. normally,. the. connector. of. the. hammer. sensor. might. be.
disconnected.
Solution.1.: Check if the connector of the sensor is disconnected. The connector is located
Solution.2.: Referring to 〔6〕 【B】 , open the connector cover of the sound source unit and
Solution.3.: Referring to 〔6〕 【B】 , open the sound source unit and check if all connectors
Solution.4.: Check if one of the relay connectors inside the sound source unit is disconnected.
are firmly inserted.
inside the side board and at the side of the bass.
check if all connectors are firmly inserted.
are firmly inserted.
– 22 –