Onboard Devices Configuration - Asus Q87I-PLUS/CSM Manual

Terminal Type [VT-UTF8]
VT‑UTF8 is the preferred terminal type for out‑of‑band management. The next best
choice is VT100+ and then VT100. Configuration options: [VT100] [VT100+] [VT‑UTF8]
[ANSI]
Bits per second [115200]
Allows you to select the transmission speed of the serial port. Configuration options:
[9600] [19200] [57600] [115200]
Flow Control [None]
Flow control prevents data loss from buffer overflow. This item allows you to set the
flow control. Configuration options: [None] [Hardware RTS/CTS] [Software Xon/Xoff]
2.6.10

Onboard Devices Configuration

HD Audio Controller [Enabled]
[Enabled]
[Disabled]
The following item appears only when you set the HD Audio Controller item to [Enabled].
Front Panel Type [HD]
Allows you to set the front panel audio connector (AAFP) mode to legacy AC'97 or high‑
definition audio depending on the audio standard that the front panel audio module supports.
[HD]
[AC97]
Intel LAN Controller [Enabled]
[Enabled]
[Disabled]
Intel PXE OPROM [Disabled]
This item appears only when you set the previous item to [Enabled] and allows you to enable
or disable the PXE OptionRom of the Intel LAN controller. Configuration options: [Enabled]
[Disabled]
2.6.11 APM
Restore AC Power Loss [Power Off]
[Power On]
[Power Off]
[Last State]
2‑28
Enables the HD Audio Device.
Disables the HD Audio Device.
Sets the front panel audio connector (AAFP) mode to high definition audio.
Sets the front panel audio connector (AAFP) mode to legacy AC'97
Enables the Intel LAN controller.
Disables the controller.
The system goes into on state after an AC power loss.
The system goes into off state after an AC power loss.
The system goes into either off or on state, whatever the system state was
before the AC power loss.
Chapter 2: Getting started