Assembling Leg Set; Attaching Feet - RIDGID MS1250 Owner's Manual

Alignment (Adjustments) (continued)
Step Three: Pivot Adjustment
NOTE: This adjustment was made at the
factory and normally does not require
readjustment.
Arm Pivot Movement
1. Make sure the see through lower guard
is rotated closed and is resting against,
or very close to, the rubber stops. If not,
see "Lubrication" section.
Bevel Pivot Movement/Adjustment
Check that miter saw bevels easily by
loosening the bevel lock handle and tilting
the power head to the left. NOTE: At least
one thread of the pivot bolt should stick
out past the hex lock nut.
1. If movement is tight or there is loose-

Assembling Leg Set

1. Locate the following parts:
4 Legs
2 Long Upper Stiffeners
2 Short Upper Stiffeners
2 Long Lower Stiffeners
2 Short Lower Stiffeners.
2. From the leg set hardware bag find the
following:
4 Feet
24 Carriage Bolts 5/16-18 x 5/8
24 Flange Nuts 5/16-18
NOTE: Hardware not shown actual size.
3. Assemble the stand as shown. Make
sure the legs go inside the upper stiff-
eners. Make sure the legs go outside
the lower stiffeners. Make sure the long
upper stiffeners go over the short upper
stiffeners.
4. Only finger tighten nuts at this time.
ness in the pivot, do the following
adjustment procedure:
a. Loosen the bevel lock handle.
b. Turn the hex lock nut with a 3/4" or
19mm socket and socket wrench.
Recheck bevel movement of the miter
saw. Readjust if necessary.
Long Upper
Stiffener
Short Upper
Stiffener
Foot
Short UIpper
Stiffener
Leg
Long Lower
Stiffener
18
Leg
Long Lower
Stiffener
Short Lower
Stiffener
Flange Nut
Bolt
Long Upper
Stiffener
Short Lower
Stiffener
Foot