Sony STR-K675P Service Manual page 9

THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed in each block.)
For Schematic Diagrams.
Note:
• All capacitors are in µF unless otherwise noted. (p: pF)
50 WV or less are not indicated except for electrolytics and
tantalums.
• All resistors are in Ω and
1 / W or less unless otherwise
4
specified.
• % : indicates tolerance.
• f : internal component.
• 2 : nonflammable resistor.
• 5 : fusible resistor.
• C : panel designation.
Note: The components identified by mark 0 or dotted
line with mark 0 are critical for safety.
Replace only with part number specified.
• A : B+ Line.
• B : B+ Line.
• Voltages and waveforms are dc with respect to ground un-
der no-signal (detuned) conditions.
No mark : FM
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal production
tolerances.
• Waveforms are taken with a oscilloscope.
• Circled numbers refer to waveforms.
• Signal path.
F : FM
J : ANALOG
c
: DIGITAL
I
: VIDEO
STR-K675P
For Printed Wiring Boards.
Note:
• X : parts extracted from the component side.
• a : Through hole.
• f : internal component.
• : Pattern from the side which enables seeing.
• Indication of transistor.
C
Q These are omitted.
B E
B C E
These are omitted.
Caution:
Pattern face side: Parts on the pattern face side seen from
(Side A) the pattern face are indicated.
Parts face side: Parts on the parts face side seen from
(Side B) the parts face are indicated.
• Waveforms
– DIGITAL Board –
1
IC1501 9 (MCLK1)
3.4 Vp-p
72 ns
1 V/DIV, 40 ns/DIV
2
IC1101 id (X1)
4.2 Vp-p
41.6 µ s
1 V/DIV, 20 ns/DIV
3
IC1301 ws (XIN)
4.4 Vp-p
81 ns
1 V/DIV, 40 ns/DIV
9 9
STR-K675P