Table of Contents
Advertisement
173B. Place the camshaft carrier on the cylinder
head. Install the 5 nuts by hand. Make sure the car-
rier enters the end guides.
174. Place the hydraulic lifters in their exact previ-
ous locations.
NOTE! Should any of the valve lifters be worn (do
not function), it has to be replaced as a unit. Lower
the lifter in clean oil and pump with the center plug
until it feels 'hard'.
175. Check to make sure that the half-moon seal in
the camshaft carrier is not damaged. Replace if ne-
cessary.
176. Grease the seal ring and install it carefully on
the camshaft.
NOTE! Turn the 'smooth' side facing outwards (to-
wards the front).
177. Install the camshaft gears on the camshaft.
Use counterhold, part no 9995034-7. Tightening
torque: 50 Nm (5.0 kpm/36 ft.lbs).
178. Place the camshafts in the camshaft carriers
so that the front lobes (No 1) are turned facing up-
ward and inward towards each other.
NOTE! The camshaft with a groove for the distrib-
utor drive, should be installed on the port side.
Check to make sure that the markings on the cam-
shaft gears are pointing up.
69
Hide quick links:
Advertisement
Table of Contents
