Dodge Durango 2016 Owner's Manual page 247

Training The Garage Door Opener
1 — Door Opener
2 — Training Button
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 245
1. Place the ignition in the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm)
away from the HomeLink button you wish to program
while keeping the HomeLink indicator light in view.
3. Push and hold the HomeLink button you want to
program while you push and hold the hand-held trans-
mitter button.
4. Continue to hold both buttons and observe the indi-
cator light. The HomeLink indicator will flash slowly
and then rapidly after HomeLink has received the
frequency signal from the hand-held transmitter. Re-
lease both buttons after the indicator light changes
from slow to rapid.
5. At the garage door opener motor (in the garage),
locate the "LEARN" or "TRAINING" button. This
can usually be found where the hanging antenna wire
is attached to the garage door opener/device motor.
3