Chevrolet Trailblazer Service Manual page 664

To Install:
1. If replacing the instrument panel (I/P), install the air distribution duct vents into the
instrument panel (I/P).
2. If replacing the instrument panel (I/P), install the inflatable restraint instrument
panel (I/P) module into the instrument panel (I/P).
3. Place the instrument panel (I/P) into the vehicle.
NOTE: Make sure that there are no wiring harnesses or connectors pinched behind
the instrument panel (I/P).
4. Seat the instrument panel (I/P) onto the positioning locators.
5. Install the middle and upper bolts into the instrument panel (I/P).
6. Install the lower retaining bolts into the instrument panel (I/P).
7. After all bolts have been installed, torque the bolts to 62 in-lb (7 Nm).
8. Install the screw into the side window defogger outlet.
9. Install the right access cover onto the instrument panel (I/P).
10. Install the upper front speaker into the instrument panel (I/P).
11. Install the upper trim pad onto the instrument panel (I/P).
12. Install the garnish molding onto the left and right A-pillars.
13. If replacing the instrument panel (I/P), install the headlamp bezel into the
instrument panel (I/P).
14. Install the headlamp switch into the instrument panel (I/P).
15. Install the left access cover onto the instrument panel (I/P).
16. Install the HVAC module harness into the instrument panel (I/P) substrate.
17. Install the front HVAC module into the instrument panel (I/P).
18. Install the radio into the instrument panel (I/P).
19. Install the instrument cluster into the instrument panel (I/P).
20. For Chevrolet vehicles, install the instrument cluster bezel into the instrument panel
(I/P).
21. For GMC and Oldsmobile vehicles, install the accessory trim plate onto the
instrument panel (I/P).
22. For GMC and Chevrolet vehicles, install the lower sound insulator panel onto the
instrument panel (I/P).
23. Install the center console into the vehicle.
24. For Oldsmobile vehicles, install the shift lever bezel from the center console.
25. Install the storage compartment door onto the instrument panel (I/P).
26. Install the right insulator panel onto the instrument panel (I/P).
27. Install the steering column into the vehicle.
28. Attach the left HVAC floor duct to the instrument panel (I/P).
29. Install the knee bolster onto the instrument panel (I/P).
30. Install the left insulator panel onto the instrument panel (I/P).
31. Connect the negative battery cable to enable the SIR system.