Switching On/Off; Selecting Functions And Adjusting; Direct Selection - Bosch CCS Operating Instructions Manual

44 | en

Switching on/off

Function
Switch on/off
Note:
Whilst the vehicle ignition is on, the
system will switch on automatically
for an incoming call if a telephone is
present that is connected directly or
via Bluetooth®.
Selecting functions and adjusting settings

Direct selection

Important and frequently used functions can
be selected directly by pressing a button on the
CCS/CCD. In order to select certain functions,
it is necessary to keep the corresponding
button pressed down longer (approximately 3
seconds).
09.2014
Switching on/off | Selecting functions and adjusting settings
Action
f Press the ON button
1
f Switch the vehicle
ignition on/off
f Switch microphone 1
(MIC1) on/off
Note
When the vehicle ignition is off, the system
switches off automatically after 1 hour to
conserve the vehicle battery.
The system will only switch on together with
the vehicle ignition if it was previously
switched off together with the vehicle
ignition.
Only when the vehicle ignition is switched
on.
The system will only switch off together with
microphone 1 (not included in the scope of
delivery) if it was previously switched on
together with microphone 1.
Note:
In order to use the functions of
certain buttons for the cabin, you
must first switch the focus of control
over to the cabin.You will find further
information about the focus of control
in the "Focus of control" section in
this chapter.
Robert Bosch Car Multimedia GmbH