Casio EX-TR600 User Manual page 146

Problem
Wireless Connection
I can't establish a
wireless connection.
The wireless
connection is
broken.
Other
The wrong date and
time are displayed,
or the wrong date
and time are being
stored along with
image data.
The messages on
the display are in
the wrong language.
Images cannot be
transferred over a
USB connection.
Language selection
screen appears
when the camera is
turned on.
There are various
indicators and
values on the
monitor screen.
Possible Cause and Recommended Action
1)The camera cannot connect with a smartphone if they are
too far apart from each other.
2)The smartphone may be connected with another wireless
device. Check the smartphone's Wi-Fi settings and confirm
that the camera is selected for wireless connection (page
91).
3)Connection may have been lost due to interference caused
by a nearby microwave oven, cordless phone, or other
wireless device. Move the camera away from the device
causing the problem.
The date and time setting is off. Set the correct date and time
(page 114).
The wrong display language is selected. Change the display
language setting (page 115).
1)The USB cable may not be connected securely. Check all
connections.
2)If the camera is not turned on, turn it on.
3)Your computer may not be able to recognize the camera if
you connect via a USB hub. Always connect directly to the
computer's USB port.
1)You did not configure initial settings after purchasing the
camera or the camera may have been left with a dead
battery. Check the camera setup (pages 26, 114).
2)There may be a problem with the camera's memory data. If
this is the case, perform the reset operation to initialize the
camera's setup (page 116). After that, configure each
setting. If the language selection screen does not re-appear
when you turn the camera on, it means that the camera's
memory management data has been restored.
If the same message appears after you turn power back on,
contact your retailer or a CASIO authorized service center.
The monitor screen shows indicators and other information
about shooting conditions and the image you are recording.
You can disable display of indicators and values by selecting
"Off" for "Info" on the Setup menu.
146
Appendix