Connecting Your Dvd Player - NEC WT615 User Manual

Connecting Your DVD Player

Optional 15-pin-to-RCA
(female) 3 cable (ADP-CV1)
Component video RCA 3 cable
(not supplied)
Audio Equipment
You can connect your projector to a DVD player with component output or Video output. To do so, simply:
1. Turn off the power to your projector and DVD player.
2. If your DVD player has the component video (Y,Cb,Cr) output, use a commercially available component
video cable (RCA 3) and the optional 15-pin-to-RCA (female) 3 cable to connect your DVD player to
the COMPUTER IN connector on the projector.
For a DVD player without component video (Y,Cb,Cr) output, use an S-Video cable (not provided) to
connect the S-Video output of the DVD player to the S-Video Input of the projector.
3. Turn on the projector and DVD player.
NOTE: Refer to your DVD player's owner's manual for more information about your DVD player's video output requirements.
NOTE: Normally switching between RGB and component signals will be performed automatically, but if it fails, from the menu
select [Setup] → [Options] → [Signal Select] → [Component] for the RGB signal.
COMPUTER IN
REMOTE PCCONTROL
IN
AUDIO IN VIDEO IN
L
R
/MONO
AUDIO IN
L R
Audio cable (not supplied)
AUDIO IN COMPUTER
PC CARD USB AUDIO IN AUDIO OUT
DVI-I COMPUTER
S-VIDEO IN DVI-I IN COMPUTER IN MONITOR OUT
DVD player
23
2. Installation and Connections
Audio cable
(not supplied)
Y Cb Cr L R
Component AUDIO OUT