Sony VPH-G70Q Installation Manual page 69

6 2
8
4 1
5
9
7 3
9 Press the V or v key to select ALL and adjust so that the spot is in
focus.
4
Press the POSITION + key once to enter the focus adjustment mode
for the upper parts.
When you press the POSITION + key, the part to be adjusted cycles
through the order as illustrated on the left. The position number is
displayed at the upper right corner.
If you press the POSITION – key, the part cycles through the reverse
order.
F O C U S A D J P O S I T I O N
- G - M G - V N o . 2
M G : 1 2 8
SEL:
A Q P : 1 2 8
NEXT:
D Q P : 1 2 8
5
Adjust the focus and AQP/DQP for the upper part of the screen (white
area 2 in the illustration on the left).
1 Press the B or b key so that the upper part of the screen is in focus.
2 Select AQP with the V or v key, and press the B or b key to correct
the vertical and horizontal distortion (AQP adjustment).
3 Select DQP with the V or v key, and press the B or b key to correct
the diagonal distortion (DQP adjustment).
4 Repeat steps 1 to 3 so that the spot becomes a correct circle.
6
Perform the magnetic focus, AQP and DQP for every part of the screen
(white areas 3 to 9 in the illustration) in numeric order.
1 Press the POSITION + key to select the part to be adjusted.
2 Press the V or v key to select the adjustment item.
3 Press the B or b key to adjust.
Repeat steps 2 and 3 for each adjustment item.
Remove the cap for magnetic focus adjustment and proceed to
adjust the red lens focus if the green magnetic focus, AQP and
DQP are completed.
If the adjustments are not complete, repeat from the green lens
focus again.
ADJ:
+ –
69
Adjustments (EN)