Switching the 75-ohm Terminate Connectors
Removing the B board
Depending on the connections of the computer and color monitor to the
projector, it may be necessary to switch the 75-ohm terminate connectors
on the B board at the rear of the projector.
1
Remove the rear cover.
For details, see "Removing the Upper, Front and Rear Covers" on
pages 17 (EN) and 18 (EN).
2
Loosen the four screws at the rear of the projector to remove the
connector panel. Unlace the coated lead pin fixing the cables to
disconnect the CN437 connector on the BC board.
3
Loosen the screw and remove the cover.
CN437
(continued)
25
Connections
(EN)