Important Notes On Operation - Sony CA-TX70 Operating Instructions Manual

Important Notes
on Operation
Use and storage locations
Store in a level, ventilated place. Avoid
using or storing the adaptor in the
following places.
• In excessive heat or cold. Operating
temperature range is –10°C to + 45°C
(14°F to 113°F). When connected to
the camcorder, the operating
temperature range is 0°C to 40°C
(32°F to 104°F).
• Remember that in summer in warm
climates the temperature inside a car
with the windows closed can easily
exceed 50°C (122°F).
• In damp or dusty locations
• Locations where the adaptor may be
exposed to rain
• Locations subject to violent vibration
• Near strong magnetic fields
• Close to radio or TV transmitters
producing strong electromagnetic
fields.
• In direct sunlight or close to heaters
for extended periods
Do not subject to strong shocks
Do not drop the adaptor or subject it to
strong shocks. The adaptor may be
damaged.
Do not wrap in a cloth or other
covering during operation
Internal temperatures may rise, causing
malfunctions.
Maintenance
Clean the cabinet and panels by wiping
lightly with a soft, dry cloth. If they are
very dirty, use a cloth dampened with a
small amount of neutral detergent, then
wipe dry. Avoid the use of volatile
solvents such as thinners, alcohol,
benzene, and insecticides. They may
damage the surface finish or cause it to
peel off.
When connecting to the HXC-D70
HD Color Camera
When you attach the adaptor to the
HXC-D70 HD Color Camera, the
following signals are cannot be
selected.
Page title Page Item
No.
<TEST M10 OUTPUT VBS
OUT>
<SDI M11 OUTPUT SD-SDI
OUT>
After the adaptor is connected, the
settings of HXC-D70 shown in the
below table, cannot be changed.
Page title Page
No.
<POWER SAVE> M13
When connecting to the PMW-500/
350/320 Solid-State Memory
Camcorder
• The skin detail gate is not
superimposed on the CCU's output
signal to a monitor.
• The time code and REC trigger signal
are not superimposed on the CCU's
SDI output.
• The TRUNK function is not
supported.
When you perform the following
operations, the picture may be distorted
or the display of the remote control may
turn off for a moment. This is not a
malfunction.
• Performing ABB
• Turning on or off the Slow Shutter
function

Important Notes on Operation

Signal
Item
SDI OUT
17