Connecting Your Dvd Player With Component Output - NEC NP 610 User Manual

Connecting Your DVD Player with Component Output

Audio Equipment
Audio cable (not supplied)
A component signal will be automatically displayed. If not, from the menu, select [SETUP] → [OPTIONS(1)] →
[SIGNAL SELECT] → [COMPUTER1], and then place a check mark in the Component radio button.
• Select the source name for its appropriate input connector after turning on the projector.
[NP610/NP510/NP410/NP310/NP510W/NP410W/NP610S/NP510WS]
Input connector
COMPUTER 1 IN
COMPUTER 2 (DVI-I) IN
[NP405/NP305]
Input connector
COMPUTER 1 IN
COMPUTER 2 IN
NOTE: Refer to your DVD player's owner's manual for more information about your DVD player's video output requirements.
COMPUTER 1 IN
AUDIO IN
L R
SOURCE button on the projector
cabinet
COMPUTER1
COMPUTER 2(ANALOG)
SOURCE button on the projector
cabinet
COMPUTER 1
COMPUTER 2
2. Installation and Connections
AUDIO IN
15-pin - to - RCA (fe-
male) × 3 cable adapter
(ADP-CV1E)
DVD player
L R Y Cb Cr
AUDIO OUT Component
Button on the remote control
Button on the remote control
22
Component video RCA × 3
cable (not supplied)
(COMPUTER 1)
(COMPUTER 2)
(COMPUTER 1)
(COMPUTER 2)