NEC MultiSync LT 80 User Manual page 22

Settings for Monitor Mode
Number of DIP switch
Monitor size
15" multi-scan mode /16"–13"
17" multi-scan mode /19"–13"
19" multi-scan mode /21"–13"
13" fixed mode /640 480
VGA/SVGA mode
16" fixed mode /832 624
19" fixed mode /1024 768
NOTE: For setting other than display modes supported by your Macintosh and LT80, using of the DIP
switch may bounce a image slightly or may display nothing. If this happens, set the DIP switch to the 13"
fixed mode and then restart your Macintosh. After that, restore to a displayable mode and then restart the
Macintosh again.
Make sure that LT80 and your Macintosh are connected with the monitor adapter and the supplied signal
cable (mini D-Sub 15-pin connector) and then restart your Macintosh.
Examples of DIP switch setting
13" fixed mode
ON
1 2 3 4 5 6 7 8
NOTE: Refer to your computer's owner's manual for more information about your computer's video
output requirements and any special identification or configuring your projector's image and monitor
may require.
INSTALLATION
S1 S2 S3 S4 S5
ON ON
ON
ON
ON
ON
ON
17" multi-scan mode
ON
1 2 3 4 5 6 7 8
S6 S7 S8
ON
ON
ON
VGA/SVGA mode
ON
1 2 3 4 5 6 7 8
41
42