Cd555 E3; Cd555 Introduction And Installation - NAIM CD555 Reference Manual

CD555

4. CD555 Introduction and Installation

The CD555 CD Player can only be operated from a Naim CD 555PS Power Supply. Connection of the power supply is
illustrated in Section 5.2. CD player control and operation is described in Sections 16, 17 and 18.
The CD555 should be installed on a dedicated equipment stand intended for the purpose. To improve sound quality the
player has hard metallic feet which may blemish any delicate surface on which it is placed. Do not stand the player directly
on top of another item of Naim Audio equipment. Care should be taken to ensure that the player is level.
Seven transit screws on the underside of the CD555 case should be removed before use and must be replaced if the unit is
to be moved or re-packed and shipped. Transit screw locations are shown, and notes on their removal are provided, below.
The transit screws must not be used in any other Naim product. Do not invert the player while removing the transit screws or
once the transit screws are removed.
The player and power supply should be installed in their final locations before connecting cables or switching on. Ensure that
power amplifiers are switched off and the preamplifier volume is turned down before the power supply is switched on. The
power button is located on the front panel.
The player and power supply are heavy and care should be taken when lifting or moving them. Make sure that the surface on
which they are to be placed can support their weight.
4.1 Transit Screws
Seven transit screws must be removed from the underside of
the CD555 before use and be replaced if the player is to be
carried any distance, packed or shipped. The transit screw
locations are illustrated in the diagram below. CD555 transit
screws must not be used with any other Naim product.
The player must not be inverted either during or after transit
screw removal.
To gain access to the transit screws, position one side of
the player over the edge of a table, remove (or replace)
the screws that become accessible and then repeat as
necessary with other sides of the player to access the
remaining screws. If the transit
screws are to be replaced the
three different types must be
used in their correct locations.
4.2 Transit Screw Locations
To identify the transit screw types refer to the following
table:
Location
A
B
C
A
B
A
E3
Screw Type
10mm White
25mm Black
Stainless Steel
C
B
A
A