Cleaning Or Replacing The Filters - NEC MultiSync LT156 User Manual

Cleaning or Replacing the Filters

The air-filter sponge keeps the inside of the MultiSync LT156/LT155/
LT154 Projector free from dust or dirt and should be cleaned after
every 100 hours of operation (more often in dusty conditions). If the
filter is dirty or clogged, your projector may overheat.
CAUTION
• Turn off the power and unplug the projector before replacing the filter.
• Only clean the outside of the filter cover with a vacuum cleaner.
• Do not attempt to operate the projector without a filter cover.
• Your projector will not operate unless the filter cover is installed cor-
rectly.
To clean the air-filter:
Vacuum the filter-through the filter cover.
To replace the air-filter:
1. Remove the filter cover by pushing down on the catch of the cover
until you feel it detach.
1
2
2. Reinstall the new filter cover.
NOTE: Do not detach the sponge from the filter cover. Do not wash the filter
cover with soap and water. Soap and water will damage the the filter mem-
brane. Before replacing the filter cover, remove dust and dirt from the pro-
jector cabinet. Keep out dust and during filter replacement.
E – 49