Table of Contents
Advertisement
QQ
3 7 63 1515 0
MECHANICAL ADJUSTMENTS
Precaution
1. Clean the following parts with a denatured alcohol-moistened
swab:
record/playback heads pinch rollers
erase head
capstan
2. Demagnetize the record/playback head with a head demagne-
tizer.
3. Do not use a magnetized screwdriver for the adjustments.
4. After the adjustments, apply suitable locking compound to the
parts adjusted.
5. The adjustments should be performed with the rated power sup-
ply voltage unless otherwise noted.
Torque Measurement
Mode
FWD
FWD
back tension
FF/REW
TE
L 13942296513
www
.
http://www.xiaoyu163.com
SECTION 5
rubber belts
idlers
Torque Meter
Meter Reading
2.9~6.9 mN•m
(30 to 70 g•cm)
(0.42 – 0.97 oz•inch)
CQ-102C
0.19~0.59 mN•m
(2 to 6 g•cm)
(0.03 – 0.08 oz•inch)
7.8~16.7 mN•m
CQ-201B
(80 to 170 g•cm)
(1.11 – 2.36 oz • inch)
x
ao
u163
y
i
http://www.xiaoyu163.com
2 9
8
ELECTRICAL ADJUSTMENTS
DECK SECTION
Precaution
1. Demagnetize the record/playback head with a head demagne-
tizer.
2. Do not use a magnetized screwdriver for the adjustments.
3. After the adjustments, apply suitable locking compound to the
parts adjust.
4. The adjustments should be performed with the rated power
supply voltage unless otherwise noted.
5. The adjustments should be performed in the order given in
this service manual. (As a general rule, playback circuit
adjustment should be completed before performing recording
circuit adjustment.)
6. The adjustments should be performed for both L-CH and R-CH.
7. Switches and controls should be set as follows unless other-
wise specified.
8. Set to the DOLBY NR OFF.
9. Set to the test mode.
(1) Press the \/1 button to turn the power ON.
(2) Select the function "TAPE A or B".
(3) Press the button of c/CLOCK SET , TUNER ENTER ,
and DISC 3 simultaneously, to set the tape deck test mode
and displays "TEST MODE" on the fluorescent indicator
tube.
(4) To release from the test mode, press the \/1 button.
• Test Tape
Tape
P-4-A100
10 kHz, – 10 dB
WS-48B
Q Q
3
6 7
1 3
1 5
co
.
HCD-XGR90AV
SECTION 6
9 4
2 8
0 dB = 0.775 V
Signal
Used for
Azimuth Adjustment
3 kHz, 0 dB
Tape Speed Adjustment
0 5
8
2 9
9 4
2 8
m
9 9
9 9
17
Advertisement
Table of Contents
