Table of Contents
Advertisement
Connecting PC as monitor
Sound adjustment
1. Press the MENU button.
2. Select the Sound menu, then press VOLÏq.
3. Press the PRxy button to select the desired
sound item; Equalizer, Balance, AVL, Surround or
Sound Mode.
4. Press the VOLÏq button to make desired adjustment.
5. Press the VOLÏq button in Equalizer to set the
Equalizer.
6. Press the PRxy button to select your preferred
setting ; Flat, Music, Movie, Speech or User.
To set the Equalizer User.
a. Select User by pressing the PRxy button.
b. Select a sound band by pressing the VOLÏq
button.
c. Make appropriate sound level with the PRxy
button.
d. Press the MENU button to return to preceding
menu.
7. Press the PRxy button to the Balance menu.
8. Select the Balance menu with the VOLÏq button and
adjust the balance of speaker.
9. Select the AVL(Automatic Volume Leveler) menu
ON or OFF.
10. Select the Surround menu ON or OFF.
11. Select the Sound Mode with PRxy button.
12. Press the VOLÏq button to select sound mode – L+R, L+L, R+R.
L+R : Audio signal from audio L input is sent to left loudspeaker and audio signal
from audio R input is sent to right loudspeaker.
L+L : Audio signal from audio L input is sent to left and right loudspeakers.
R+R : Audio signal from audio R input is sent to left and right loudspeakers.
13. Select the Input with PRxy button.
14. Press the VOLÏq button to select Input – PC, Radio.
Note:
a. When selecting radio mode, sound mode alternates between MONO and
STEREO according to the received signal.
b. In PC mode, radio mode supports only Auto.
c. In PC mode, radio control function is on an equality with Radio function in
the front.(See page 20)
26
Sound
Equalizer
Balance
0
AVL
Off
Surround
Off
Sound Mode
L+R
Input
PC
Position :
Next :
Back : MENU
Exit : TV/AV
Equalizer
Flat
Music
Movie
Speech
User
0.1 0.5 1.5 5.0 10KHz
Position :
Back : MENU
Exit : TV/AV
Connecting PC as monitor
Position Adjustment
This function is to adjust picture to left/right and up/down
as you prefer.
1. Press the MENU button.
2. Select the H/V Position menu.
3. Press the PRxy button to select the desired
position item.
4. Press the VOLÏq button to adjust horizontal
position and vertical position.
5. Press the TV/AV button to exit menu
Auto
This function is for the automatic adjustment of the screen position, clock and
clock phase. The displayed image will disappear for a few seconds while the
Auto-configuration is in process.
Note: Some signal from some graphics boards may not function properly.
If the results are unsatisfactory, adjust your monitor's position, clock and clock
phase manually.
Reset
This function allows you to return to the good picture reproduction programmed
at the factory and cannot be changed.
H/V Position
H-Position
0
V-Position
0
Position :
Adjust :
Back : MENU
Exit : TV/AV
27
Advertisement
Table of Contents
