Table of Contents
Advertisement
Using the Caller ID Message List
Calling a Party from the Caller ID List
Standby Mode
1
When the phone is in standby mode, select the Caller ID message (see "Viewing
the Caller ID List" on
2
To have the phone dial a "1" before the displayed Caller ID number, press
<
. To have the phone dial the stored area code before the displayed Caller
/tone/
*
ID number, press #/
3
Press talk/flash or speaker. The displayed phone number dials automatically.
Talk Mode
1
When the phone is in talk mode, select the Caller ID message you want to dial (see "Viewing the Caller ID
List" on
page
23).
2
Press the
DIAL
Storing Caller ID Messages in the Phonebook
Messages shown in the Caller ID list can be stored in the phonebook. The phone number and name of the
party on the Caller ID list can be stored in memory.
1
When the phone is in standby mode, select the Caller ID message to be stored.
Then press the
memory, you will hear a beep and T hi s d at a is al re ad y s to re d! ! appears. The number will not be
stored.
2
To complete the setting, follow the steps 3-8 in "Phonebook (Storing Phone Numbers, Names, Distinctive
Rings, and Speed dial)" on
• When a long distance call has been set, "
note
• If the Caller ID message was received as a private/unknown number, or the message does not have the number, you
cannot store the message in the Phonebook. If it was received as private/unknown name, the message will be stored as
<No Name>.
• Even if the 100 memory locations are full, the message will be stored in the Phonebook. However, the message will be
erased from the Caller ID list.
[ 2 4 ]
page
23).
>.
soft key, and the number will be dialed.
soft key. St o re /E di t N am e appears. If the Caller ID message is already stored in
STORE
page
19.
1
" appears in the display.
G e t t i n g S t a r t e d
Advertisement
Table of Contents
