Spark Plug; Cooling System - Echo SHC-210 Operator's Manual

SPARK PLUG

Level 2.
Tools Required: T-Wrench, feeler gauge, soft metal brush
Parts Required: REPOWER
IMPORTANT
Use only NGK BPM-8Y spark plug (BPMR-8Y in Canada) otherwise
severe engine damage may occur.
1. Remove spark plug and check for fouling, worn and rounded
center electrode.
2. Clean the plug or replace with a new one. DO NOT sand blast to
clean. Remaining sand will damage engine.
3. Adjust spark plug gap by bending outer electrode.
4. Tighten spark plug to 150-170 kg/cm (130-150 in. lb.).

COOLING SYSTEM

Level 2.
Tools required: Cross head screwdriver, 3 mm, 4 mm hex wrench,
25 or 50 mm (1 or 2 in.) cleaning brush
Parts Required: None.
IMPORTANT
To maintain proper engine operating temperatures, cooling air must
pass freely through the cylinder fin area. This flow of air carries
combustion heat away from the engine.
Overheating and engine seizure can occur when:
• Air intakes are blocked, preventing cooling air from reaching the
cylinder.
• Dust and grass build up on the outside of the cylinder. This build-
up insulates the engine, and prevents the heat from escaping.
Removal of cooling passage blockages or cleaning of cooling fins is
considered "Normal Maintenance." Any failure attributed to lack of
maintenance is not warranted.
TM
Tune-Up Kit P/N 90074
H C
EDGE
O ' M
PERATOR S
0.65 mm
(0.026 in.)
LIPPER
17
ANUAL