Adjusting The Channel Settings - Haier LE32A650CF Instruction Manual

Using Your TV
Reset
To reset audio settings to the factory defaults.

Adjusting the Channel Settings

Tuner Mode
Video
Audio Channel
Channels
Audio
Time Shift Mode
Device Info
TV
Setup
Lock
Tuner Mode
To select the tuner mode: Antenna/Aerial or Cable.
Audio Channel (ATV only)
To select the audio mode for a multiple audio or
stereo broadcast programme.
Audio Language (DTV only)
To select audio language for programmes that have
multiple language tracks.
Audio Language 2nd (DTV only)
To select second preferred audio language for
programmes that have multiple language tracks.
Channels
To perform channel scan and edit channel list.
Channel Scan
To perform channel scan after selecting your
country and configuring your cable information
(cable mode).
Update Scan
To perform channel scan update to add channels
to the existing channel list.
Analogue Manual Scan
To perform analogue manual scan up or down
from the specified start frequency.
Search for analogue channels
Video
Audio
Start Frequency (MHz)
TV
Scan up
Setup
Scan Down
Lock
1.
Press / to highlight Start Frequency
(MHz), then use the number buttons on the
remote control to enter the start frequency.
EN-14 LED Backlit Flat TV Instruction Manual
Cable
Stereo
Off
Enter Select Exit
Off
48.25
Enter Select Exit
2.
Press / to highlight Scan up or Scan
Down, then press OK to scan for higher or
lower frequency channels from the start
frequency.
Single RF Scan (Digital channel only)
To perform single RF scan and check the signal
strength and quality.
Antenna Mode
Scan single RF channel. (Digital Only)
Video
Audio
RF Channel
TV
Signal Level
Signal Quality
Setup
Lock
1.
Use the number buttons on the remote
control to enter the RF channel.
2.
Press OK to start scanning.
Cable Mode
Scan single RF channel. (Digital Only)
Video
Audio
Frequency (KHz)
TV
Modulation
Symbol Rate (Ksym/s)
Setup
Lock
1.
Press / to highlight Frequency (KHz),
then use the number buttons on the remote
control to enter the frequency.
2.
Press / to highlight Modulation, then
press / to select the modulation type.
3.
Press / to highlight Symbol Rate (Ksym/s),
then use the number buttons on the remote
control to enter the symbol rate.
4.
Press OK to start scanning.
Favorite Network Select
To select the network you prefer if there are more
than two networks detected after running the
channel scan.
Channel Skip
To select the channels that will be skipped when
using the P /P buttons. You can still tune to
the skipped channels using the number buttons
on the remote control.
1.
Press / to highlight the channel that you
want to skip, then press OK.
displayed.
Antenna
Off
0%
41
0%
0%
Enter Select Exit
Cable
Off
0%
30600
Auto
6875
Enter Select Exit
will be