Getting Started; Preparing Your Remote Control; Installing The Batteries; Remote Control And Battery Cautions - Haier LE32A650CF Instruction Manual

Getting Started

Preparing Your Remote Control

Installing the Batteries

1.
Open the battery cover.
2.
Install two AAA batteries. Make sure that you
match the + and – symbols on the batteries with
the + and – symbols in the battery compartment.
3.
Replace the battery cover.

Remote Control and Battery Cautions

• Ensure that there is nothing between the remote
control and the remote sensor of the TV set.
• Use the remote control carefully. Do not drop the
remote control on the floor.
• Sunlight, or other strong light, will interfere with
the signal from the remote control. Avoid using
near fluorescent lights or neon signs.
• Do not place the remote control in direct heat or in
a damp place as you may damage the remote.
• Danger of explosion if battery is incorrectly
replaced. Replace only with the same or equivalent
type. The batteries (battery pack or batteries
installed) shall not be exposed to excessive heat
such as sunshine, fire or the like.
• If your TV is not to be used for a long period of time,
remove the batteries from the remote control.
• Do not dispose of the batteries with standard
household waste. Do not throw them in a fire.
Dispose of the battery according to local
regulations.

Initial Setup

The first time you turn on your TV, the setup wizard
guides you through setting up basic settings including
the menu language, country, password, signal type
and channel scan.
1.
Make sure that you have:
• Installed the remote control batteries. (See page
9 for details)
• Connected an antenna or cable TV. (See page 7
for details)
• Connected the power cord to the AC IN jack on
the back of the TV and to a working power outlet.
For LE32A650CF, just connect the attached power
cord to a working power outlet.
2.
Press to turn on the TV. The setup wizard screen
opens. Press OK to start the wizard.
3.
Press / to highlight your language, then press
to continue.
Initial Setup
Please select your language:
Back Select
4.
Press / to highlight your country, then press
to continue.
Initial Setup
Please select your country:
Switzerland
Czech Republic
Back Select
5.
Enter your new 4-digit password twice, then press
OK to continue.
Initial Setup
Please set password. "0000" is not a valid password
New Password
Confirm Password
Back Select
LED Backlit Flat TV Instruction Manual EN-9
Getting Started
Language
English
Français
Italiano
Español
Deutsch
Next
Country
Austria
Belgium
Germany
Next
Next
EN