Roland GA-212 Owner's Manual page 8

Panel Descriptions
Rear Panel (Connecting Equipment)
AC IN Jack
Connect the provided
power cord to this jack.
To a power supply
[AUTO OFF] Switch
CAUTION
This switch controls the AUTO OFF function
that automatically switches o the unit after
the xed time has elapsed.
When the AUTO OFF function is switched
on, the unit will automatically be turned o
approximately 4 hours after last use.
If you don't want the unit to turn o
automatically, set the switch to OFF.
To turn the unit back on after the AUTO OFF
function has turned the unit o , turn the [ON]
switch back on (p. 5), or set the [AUTO OFF]
switch to OFF.
6
FOOT CONTROL/LINK IN, LINK OUT Jacks
FOOT CONTROL jack
This is for connecting a stereo cable to the GA FOOT
CONTROL jack of the foot controller.
* Always use a stereo cable.
LINK IN jack/LINK OUT
jack
Use these jacks to make link
connections for GAs.
p. 9
For details, see
MAIN IN Jacks
To output the sound created with a multi-e ects unit or
other devices, connect to the MAIN IN jacks.
GA-212 plays the A jack input sound from the left speaker,
and the B jack input sound from the right speaker. When
only the A jack is used, the same sound is played from the
right and left speakers. When only the B jack is used, sound
is only played from the right speaker.
GA-112 mixes the A and B jack input sounds and plays from
the speaker.
CAUTION
* If the AUTO OFF function is switched on, and only the signals
from the MAIN IN jack are input with no other operation, after
approximately 4 hours the unit is automatically turned o .
THRU/TUNER OUT Jack
A guitar's direct sound from the INPUT jack is output.
Use this to make unit link connections.
For details, see
A tuner can also be connected.
*1
p. 9
LINE OUT Jack
This is for connecting a PA
system, recorder or other
external equipment.