Before Starting En Gine; Fill Engine With Oil; Fill Gasoline Tank; To Start Engine - Poulan Pro PR500N21SH Operator's Manual

BEFORE STARTING EN GINE

Read the engine manual packed with your mower.

FILL ENGINE WITH OIL

Your lawn mower is shipped without oil in
the engine.
• Be sure mower is level and area around
oil fill is clean.
• Remove engine oil filler plug (oil fill cap/
dipstick on models so equipped).
• Slowly add oil. For type and grade of
oil to use, see "ENGINE" in the Mainte-
nance section of this manual.
• Fill to the top of slot in filler hole (to
"FULL " line on dipstick on models so
equipped). Do not overfill.
• Replace plug (oil fill cap/dipstick on
models so equipped) and tighten.
• Check oil level before each use. Add oil
as needed.
• To change oil, see Maintenance section
of this manual.

FILL GASOLINE TANK

• Fill gasoline tank with fresh, clean,
unleaded gaso line. DO NOT USE PRE-
MIUM GASOLINE. BE CARE FUL NOT
TO OVERFILL TANK.
WARNING: Al co hol blended fuels (called
gaso hol or using ethanol or metha nol) can
at tract mois ture which leads to sepa ra tion
and for ma tion of acids during storage.
Acidic gas can damage the fuel system
of an en gine while in stor age. To avoid
engine prob lems, the fuel system should
be emptied before stor age of 30 days
or longer. Drain the fuel tank, start the
engine and let it run until fuel lines and
car bu re tor are empty. Use fresh fuel next
season. See Stor age In struc tions for
ad di tion al in for ma tion. Never use en gine
or car bu re tor clean er prod ucts in fuel tank
or per ma nent dam age may occur.
TO STOP ENGINE
• To stop engine, release operator pres-
ence control bar and/or place engine
START/STOP switch (if equipped) in the
OFF po si tion.
NOTE: For engines with a primer, it may
be nec es sary to repeat priming steps
in cooler weather. In warmer weath er,
overpriming may cause flood ing and
en gine will not start. If you do flood
engine, wait a few minutes before
attempting to start and DO NOT repeat
priming steps.
OPERATION
Recoil
starter
handle

TO START ENGINE

CAUTION: The mow er blade rotates
whenever the engine is running.
NOTE: Due to protective coatings on the
engine, a small amount of smoke may be
present during the initial use of the prod-
uct and should be considered normal.
• Place engine START/STOP switch (if
equipped) in the ON po si tion.
• Move engine speed control to FAST po-
sition (or to CHOKE/START position on
models equipped with choke feature).
• If your mower has a primer, to start a
cold engine, push primer as many times
as in struct ed in the engine manual
packed with your mower. Use a firm
push. This step is not usually nec es-
sary when start ing an engine which has
already run for a few minutes.
• Hold operator presence control bar
down against han dle.
MODELS WITH RECOIL START ER
• Pull starter handle quickly. Do not allow
starter rope to snap back.
MODELS WITH ELECTRIC START ER
• Push the engine start button (or turn the
key on models so equipped).
IMPORTANT: Do not crank engine more
than five continous seconds each time you
try to start. Wait 5 to 10 seconds between
each attempt.
ALL MODELS
• For engines equipped with choke,
slowly move engine speed control lever
to FAST after engine starts.
14
Operator
presence
control bar