Data Remaining - Brother MFC-J480DW User Manual

Error Message
Cannot Print
Replace Ink

Data Remaining

Disconnected
Document Jam
DR Mode in Use
High Temperature
Ink Absorber Full The ink absorber box or flushing box must be replaced. Call Brother
Action
One or more of the ink cartridges have reached the end of their lives.
Replace the ink cartridges.
For more information, see the Online User's Guide: Replace the Ink
Cartridges.
• You can still scan even if the ink is low or needs to be
replaced.
Press Stop/Exit. The machine will cancel the job and clear it from the
memory. Try to print again.
Try to send or receive again.
If calls are stopped repeatedly and you are using a VoIP (Voice over
IP) system, try changing the Compatibility to Basic (for VoIP).
See Related Information: Telephone Line Interference/VoIP at the end
of this section.
The document was not inserted or fed correctly, or the document
scanned from the ADF was too long.
See Related Information: Document Jams at the end of this section.
The machine is in Distinctive Ring mode. You cannot change the
Receive Mode from Manual to another mode.
Set Distinctive Ring to Off.
For more information, see the Online User's Guide: Turn off Distinctive
Ring.
After cooling the room, allow the machine to cool down to room
temperature. Try again when the machine has cooled down.
Customer Service or a Brother Authorized Service Center to have your
machine serviced.
Reasons for cleaning are:
1. The machine automatically cleans itself after you remove the
power cord and plug it back in.
2. After a paper jam has been cleared, the machine automatically
cleans itself before the next received page is printed.
3. The machine automatically cleans itself after sitting idle for more
than 30 days (infrequent use).
4. The machine automatically cleans itself after ink cartridges of the
same color have been replaced 12 times.
36