Enter Setup; Start Normal Operation - Navman Sport Tool M300 User Manual

M300 - Getting started

3.3.1 Enter setup

To enter setup
Press and hold
When the counter reaches zero, the M300 will enter setup. If
you release
immediately start normal operation.
Note: To enter setup after starting normal operation you will need
to restart the M300. For details about changing settings see Section
4.0.
To leave setup
Press and hold
When the counter reaches zero, the M300 will leave setup and
start normal operation in Speed mode. If you release
the counter reaches zero the M300 will remain in setup.
Note: you must leave setup first if you want to turn the power off.

3.3.2 Start normal operation

To start normal operation
Press to turn the power on and start normal operation.
When starting directly into normal operation, the M300 will start
in the mode it was in at last shutdown. (Speed mode is always
displayed first when starting normal operation after leaving
setup.) For details about normal operating modes see Section
5.0.
1-10
to turn the power on and enter setup.
counter
before the counter reaches zero the M300 will
to leave setup and start normal operation.
counter
M300
NAVMAN
before