Canon iP1000 Simplified Service Manual page 13

7. SPECIAL NOTES ON SERVICING IN ASIA
- Elimination of Major Component Connectors on the Logic Board Ass'y -
In the iP1000, the LF and CR motors are soldered to the logic board ass'y, and the connectors which
were used in prior models are eliminated.
In addition, the CR flexible cable is soldered to the print head to eliminate the connector. (However,
in peak periods of production, instead of soldering, the connector may be used for the CR flexible
cable on the print head side.)
<Special notes on servicing>
In replacing the logic board ass'y, remove the solder from the backside of the logic board's LF and
CR motor cable connections, and re-solder them to the replaced logic board ass'y.
Regarding the CR flexible cable, as there is no service part setting, no solder removal or re-soldering
of the cable itself is required.
Logic Board Ass'y
CR Flexible Cable (Print Head Side)
13