Storage Features; Cantilever Shelves; Turning The Cooling System On And Off - Frigidaire GLVC 25V7 Use & Care Manual

Using The Alarm Reset Button
You can disable or activate the alarm system by pressing and
holding the Reset button for three seconds. Use it, for example, to
turn off audible tones and/or flashing indicator lights.
Caution
The alarm system does not automatically reset if you
disconnect and reconnect your refrigerator's power cord. It can
only be reactivated by pressing the Alarm Reset button.
Once you disable the alarm system, you must again press and hold
the Alarm Reset button for three more seconds to reset (activate)
the alarm system. The On indicator light remains off while the
freezer and refrigerator compartments cool toward the current
cooling settings. When temperature settings are reached, the On
light displays green to indicate an active alarm system.
Checking the Air Filter Status (Select Models)
Your refrigerator's fresh food air filter needs to be replaced from
time to time. You can monitor the need for replacement by pressing
and holding the Air Filter On/Off button for three seconds.
To check the air filter status:
Press the Air Filter On/Off button. This activates a test cycle, and
1
one of the three filter status lights displays, indicating one of the
following:
Air filter does not need changing.
Filter OK
Air filter is about 80 percent used. Please order new
Order Filter
one.
Air filter is 100 percent used. Please change now.
Change Filter
Press the Air Filter On/Off button to turn off the status light.
2
Note
See the later section in this Use & Care Guide for instructions
on replacing the filter.

Turning The Cooling System On And Off

You can disable the cooling system in your refrigerator by pressing
the system's On/Off button located on the left side of the
temperature control panel.
To ensure that you do not accidentally turn off the cooling system,
the button does not work unless you press and hold it for three
seconds.
Once you disable the cooling system, all refrigeration to the freezer
and refrigerator compartments stops. To turn the cooling system
back on, you must again press and hold the On/Off button for three
more seconds.
Downloaded from Fridge-Manual.com Manuals
Important
The On/Off button only controls your refrigerator's cooling
system. Power to lights and other electrical components
continues unless you unplug the power cord.

Storage Features

Caution
To avoid injury from breakage, handle tempered glass shelves
carefully.

Cantilever Shelves

You can easily adjust shelf positions in the freezer and fresh food
compartments to suit your needs. The shelves have mounting
brackets, which attach to slotted supports at the rear of each
compartment.
To change the position of a shelf:
Before adjusting a shelf, remove all food.
1
Lift the front edge up.
2
Pull the shelf out.
3
Replace by inserting the mounting bracket hooks into the desired
4
support slots.
Lower the shelf and lock into position.
5
Shelf Features
Your refrigerator includes glass shelves, which are designed to
catch and hold accidental spills. These shelves slide out for easy
access to food and faster cleaning.
Sliding shelves can be pulled forward as far as their built-in stops
allow. Sliding shelves cannot be separated from their mounting
brackets.
7