Connecting The Cvs-1450 Device To The Development Computer - National Instruments NI Vision CVS-1450 Series User Manual

Chapter 2 Setup and Configuration

Connecting the CVS-1450 Device to the Development Computer

Note If you are not connecting through a network, use an Ethernet crossover cable to
connect the CVS-1450 device directly to the development computer.
1 Standard Ethernet Cable Connecting from the CVS-1450 Device to an Ethernet Hub
2 Standard Ethernet Cable Connecting from an Ethernet Hub to the Development Computer
3 Ethernet Hub or Other Network Port
NI CVS-1450 Series User Manual
The development computer communicates with the CVS-1450 device over
an Ethernet connection. Use a standard Ethernet cable to connect from the
network port to the CVS-1450 device.
To connect the CVS-1450 device to the development computer, refer to
Figure 2-5 while completing the following steps:
1. Verify that the development computer is connected to the network and
is powered on.
2. Using a standard CAT-5 Ethernet cable, connect from the network port
to the Ethernet port on the CVS-1450 device.
3. Using a standard CAT-5 Ethernet cable, connect from the network port
to the Ethernet port on the development computer.
1
Figure 2-5. Ethernet Connection
2-12
2
ni.com