Sony ODS-D55U Operation Manual page 26

English
Before operating the unit, please read
this manual thoroughly and retain it for
future reference.
For French, German, Italian and Spanish, see
the supplied Operation manual CD-ROM.
WARNING
To reduce the risk of fire or electric
shock, do not expose this apparatus to
rain or moisture.
To avoid electrical shock, do not open
the cabinet. Refer servicing to
qualified personnel only.
WARNING
When installing the unit, incorporate a
readily accessible disconnect device
in the fixed wiring, or connect the
power plug to an easily accessible
socket-outlet near the unit. If a fault
should occur during operation of the
unit, operate the disconnect device to
switch the power supply off, or
disconnect the power plug.
When installing the installation space
must be secured in consideration of the
ventilation and service operation.
• Do not block the ventilation slots at
the Front side and rear side panels,
and vents of the fans.
• Leave a space around the unit for
ventilation.
• Leave more than 40 cm of space in
the rear of the unit to secure the
operation area.
When the unit is installed on the desk or
the like, leave at least 4 cm of space in
the left and right sides. Leaving 40 cm
or more of space above the unit is
recommended for service operation.
Do not turn on the unit with its cover
removed. It may cause electrical shock
or injury.
WARNING: THIS WARNING IS
APPLICABLE FOR USA ONLY.
If used in USA, use the UL LISTED
power cord specified below.
26
DO NOT USE ANY OTHER POWER
CORD.
Plug Cap Parallel blade
(NEMA 1-15P Configuration)
Cord Type NISPT-2 or SPT-2, two
16 or 18 AWG wires
Length Minimum 1.5 m (4 ft. 11in.),
Less than 2.5 m (8 ft. 3in.)
Rating Minimum 7A, 125V
Using this unit at a voltage other than
120V may require the use of a different
line cord or attachment plug, or both.
To reduce the risk of fire or electric
shock, refer servicing to qualified
service personnel.
WARNING: THIS WARNING IS
APPLICABLE FOR OTHER
COUNTRIES.
1. Use the approved Power Cord (2-
core mains lead) / Appliance
Connector / Plug that conforms to the
safety regulations of each country if
applicable.
2. Use the Power Cord (2-core mains
lead) / Appliance Connector / Plug
conforming to the proper ratings
(Voltage, Ampere).
If you have questions on the use of the
above Power Cord / Appliance
Connector / Plug, please consult a
qualified service personnel.
IMPORTANT
The nameplate is located on the
bottom.
For the customers in the U.S.A
This equipment has been tested and
found to comply with the limits for a
Class A digital device, pursuant to Part
15 of the FCC Rules. These limits are
designed to provide reasonable
protection against harmful interference
when the equipment is operated in a
commercial environment. This
equipment generates, uses, and can
radiate radio frequency energy and, if
not installed and used in accordance