DVR1C1161 | Installation Manual | Chapter 2
2.4.3 Single camera
The drawing below shows how to connect a single to
the DVR.
•
Connect the monitor to the BNC socket marked
Video Out on the rear of the DVR.
•
Connect the video output of the camera to the BNC
socket marked Video In on the rear of the DVR.
Power switch
Power
AC 100-240
100-240 Vac
Bosch Security Systems | 2004-6
Audio
Mux main
Monitor In
In1
In2
Off
Out1
Out2
Monitor Out
•
Connect the audio output of the camera to the socket
marked Audio In on the rear of the DVR.
•
Connect the socket marked Audio Out on the rear of
the DVR to an audio amplifier.
•
In the system menu set the multiplexer item to Off.
Camera
RS-232
connector
Video
S-Video
In
Looping out
In
Out
Out 1
Out 2
Monitor
IR remote
control eye
connector
RS 232
Remote Control
GND
VEXT
EN | 11
LAN
Network connector