Stanley TLM99 User Manual

GB
TLM99 / TLM99s/ TLM99si
Please read these instructions before operating the product.
STHT77138X/STHT77343 /STHT77361

Contents

•

User Safety

• Laser Measuring Tool Description
• Battery Installation
• Product Overview Tlm99
• Product Overview TLM99s and TLM99si
• Product Operation
• Bluetooth Operation
• Specification
• Warranty
• Error Codes
User Safety
WARNING:
• Carefully read the Safety Instructions and Product Manual before using
this product. The person responsible for the instrument must ensure that all
users understand and adhere to these instructions.
WARNING:
• The following label information is placed on your laser tool to inform you of
the laser class for your convenience and safety.
The TLM99 Products emit a visible laser beam as shown in Figure A. The laser beam
emitted is Laser Class 2 per IEC 60825-1 and complies with 21 CFR 1040.10 and
1040.11 except for deviations pursuant to Laser Notice No. 50, dated June 24, 2007
WARNING:
• While the laser tool is in operation, be careful not to expose your eyes to
the emitting laser beam (red light source). Exposure to a laser beam for an
extended time may be hazardous to your eyes. Do not look into the beam
with optical aids.
FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and the receiver
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help
Canada, Industry Canada (IC) Notices
Class B digital circuitry of this device complies with Canadian ICES-003. This device
complies with Industry Canada license-exempt RSS standard(s). Operation is subject
to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause
undesired operation of the device.
Under Industry Canada regulations, the radio transmitter(s) in this device may only
operate using an antenna of a type and maximum (or lesser) gain approved for the
transmitter by Industry Canada. To reduce potential radio interference to other users,
the antenna type and its gain should be so chosen that the equivalent isotropically
radiated power (e.i.r.p.) is not more than that necessary for successful communication.
WARNING
Indicates a potentially hazardous situation or an unintended use which, if not avoided,
will result in death or serious injury.