Advertisement
Enter menu #5 to configure the timecode settings for the DA-98. The following submenus
should be available:
Enter the 'TC Frame' submenu. Set the frame rate to the same as set in the Digital 328 timecode
setup. Press <ENTER> to confirm and enter the 'OutTc Tmg' menu. Set this to 'Digital' so the
timecode is output from the DA-98 with reference to the digital output rather than the analogue
output. Press <ENTER> to confirm and enter the 'OutTc Src' submenu. Set this to 'Tape (Abs)'
so that the DA-98 timecode generation is referenced from the loaded DTRS cassette. Press
<ENTER> to confirm and <ESCAPE> to return to the main menu page.
Enter menu #7 to enable or disable MTC output, as required. The following submenus should
appear:
Enter the 'MTC Out' submenu and enable or disable the MTC output. If MTC is to be used, 'Fast '
and 'Stop' should also be set in this menu.
With a DA-98HR, 24 bit wordlength can be selected. If this is set to on,
NOTE
24 bit should also be set as the wordlength in the Digital 328 Tape Port
Select menu (see page 4).
To complete the setup, turn on the 328 again.
Tascam DTRS Setup Guide
9
Advertisement
