Table of Contents
Advertisement
MOUNTING THE LENS
2
1
4
3
2, 3
3
1
ADJ.
LOCK
4
7
English
Pin layout
DC type lenses
1
Brake coil (–)
2
Brake coil (+)
3
Drive coil (+)
4
Drive coil (–)
Flange-back adjustment
If the pick-up surface is not correctly positioned with relation to the lens focal point, the picture will be out of
focus (in particular when using auto-iris power zoom lenses, sold separately). If that is the case, adjust the
flange-back position as described below.
1
Using a + screwdriver, loosen the FLANGE BACK LOCK screw (M2:+).
2
Set the zoom lens to the maximum telephoto position, set the focus using the focus ring on the lens.
3
Set the zoom lens to the maximum wide angle position, set the focus using the FLANGE BACK ADJ. screw.
4
Repeat steps 2 and 3, until the image stays in focus when changing from a telephoto shot to a wide angle shot.
When the setting is complete, tighten the FLANGE BACK LOCK screw.
Advertisement
Table of Contents
