Advertisement
STEP
ACTION
10 (con't)
BLOCK size (0=variable length)
Use DEVICE BUFFERS during writes
Use EXTENDED filemarks
BLOCKSIZE for variable length support
DENSITY setting #1
DENSITY setting #2
Set delay after a FAILED command
Set maximum delay for the READ/WRITE command
Select DO.
11
To leave smit, select Done, Cancel, Cancel, and Cancel. The smit window will close.
12
To test the M2488 save the "passwd" file to tape using the tar command:
tar -cvf /dev/rmt0 /etc/passwd
The system responds with: a /etc/passwd 1 blocks
Note: depending on the size of the file, a different number of blocks may be reported.
13
Verify that the "passwd" file was saved to tape by executing the following command:
tar tf /dev/rmt0
The system responds with: /etc/passwd
Installation and verification of the system is now complete.
NOTES
It is assumed that the user has a standard M2488 and is familiar with the SCSI-2 standard and host operating system
conventions.
The user assumes all responsibility for understanding the interrelationships of this information with other affected
software or system products. Fujitsu Computer Products of America (FCPA) provides this information as a service
only, and assumes no responsibility for any damages which could result from the use of this information.
The information in this application note is subject to change without notice and is not to be construed as a commit-
ment by FCPA.
May 1996
0
YES
YES
Do not set to NO
0
09
09
10
120
CG00000-016401
3 of 4
Advertisement
