Remove The K-Board; Replace The Plasma Panel - Panasonic TC-P50X1 Service Manual

3. Remove the screws (×2
unit.
4. Disconnect the connector (S2).
5. Remove the Power Button.
6. Remove the screw (×1

7.20. Remove the K-Board

1. Remove the Cabinet assy. (See section 7.18.)
2. Remove the S-Board. (See section 7.19.)
3. Remove the screws (×7
4. Remove the Glass holder bottom rear.
5. Remove the screws (×4
6. Remove the Glass holder side (L, R).
7. Remove the screws (×9
8. Remove the Glass holder top rear and the Glass holder
top front.
9. Remove the Glass holder bottom front.
) and remove the S-Board
) and remove the S-Board.
).
).
).
10. Remove the screw (×1
11. Remove the claw (×1
12. Disconnect the connector (K1) and Remove the K-Board
from LED Panel.

7.21. Replace the plasma panel

1. Place the new plasma panel on the flat surface of the
table (covered by a soft cloth), with the plasma panel sur-
face facing downward.
2. Attach the C1-Board, C2-Board and the C3-Board, con-
nect the flexible cables (×11) from the plasma panel to the
C1-Board, C2-Board and the C3-Board, and fit the flexi-
ble cable holders.
3. Attach the Hooks (left, right) and fit the Stand brackets (L,
R) to the new plasma panel.
4. Place the plasma panel section on the servicing stand.
5. Attach the cabinet assy and each P.C.Board and so on, to
the new plasma panel.
*When fitting the cabinet assy, be careful not to allow
any debris, dust or handling residue to remain
between the front glass and plasma panel.
22
).
).