Napoleon GDS25N GDS25P Installation And Operation Instructions Manual page 20

20
Remove the backing from the the logo and position onto the
control door as shown.
It is not necessary to remove the cast front, however, this
will make for a more simple log installation.
In order to assemble the log set, the door must be removed,
see Cast Front / Glass Door Removal in the FINISHING
section of this manual.
FIGURE 33a-d
LOG LOCATING SCREWS
BRACKET
1. Place the rear log, as shown, onto the rear log support
brackets. Ensure the cutout on the left underside of the log,
fi ts over the pilot assembly. Bend the bracket on the right side
to help retain the rear log.
W415-0547 / B / 05.08.06
LOGO PLACEMENT
LOG PLACEMENT
2. Place the hole in the underside of log #2 onto the locating
screw, on the left side of the burner. The fi bre burner is formed
to cradle the centre of the log.
3. Place the hole in the underside of log #3 onto the locating
screw, on the right side of the burner. The bottom branch of
log #3 sits infront of, and against, the right end of log #2.
4. Reinstall the glass door & front.
1.27cm
LOGO
1.27cm