Assembly; Operation; Packing List - Husky H100FS Operator's Manual

UNPACKING
This product has been shipped completely assembled.
 Carefully remove the tool and any accessories from the
box. Make sure that all items listed in the packing list are
included.
WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
could result in serious personal injury.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
 If any parts are damaged or missing, please call
for assistance.
1-866-340-3912
DANGER:
Do not use oxygen, combustible gases or bottled gases
as a power source for this tool. The tool will explode and
cause death or serious injury.
WARNING:
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is
sufficient to inflict severe injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
WARNING:
Disconnect the tool from the air supply before leaving the
work area, moving the tool to another location, or handing
the tool to another person. Failure to do so could result
in serious personal injury.

ASSEMBLY

PACKING LIST

Stapler
Sample Fasteners
Oil (If part of a multi tool kit only 1 oil bottle per combo)
Hex Keys (3 mm and 4 mm)
Operator's Manual
WARNING:
If any parts are damaged or missing do not operate this
tool until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this tool or create accessories
not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.

OPERATION

APPLICATIONS
You may use this tool for the purposes listed below:
 Finish and Trim (Interior and Exterior)
 Floor Underlayment
 Cabinet Work
 Casebacks
 Furniture
 Light Trim Moldings
 Fascia and Soffits
 Drawers
 Staircases
 Carpet installation
 Mirror and Picture Frames
 Crafts
 Lattice
9 – English