Installation Manual
Confirming the elite Panaboard Operation
After assembling the elite Panaboard, confirm that it operates properly by following the procedure below.
Action
1
Turn on the power.
Confirming the Interactive Features
1.
Following the procedure in "Installing the elite Panaboard software" (page 20), install the software
and, and connect the included USB cable.
2.
Confirm that the interactive features are operating correctly.
•
If a projector is not available, confirm operation using only the elite Panaboard and computer.
•
When the elite Panaboard software starts, the calibration screen is displayed on the computer screen.
•
Perform tentative calibration by pressing the 5 points on the elite Panaboard with the electronic pen,
as shown in the illustration below.
For precise adjustment, it is necessary to use a projector.
54
Operating Instructions (For Basic Operations)
Operation
Green LED lights.
Green LED does not light, or
red LED is blinking.
1
4
Checkpoints
(Normal operation)
Check the power cord.
See step 1 of "Assembling the elite Panaboard".
•
For Wall Mounting (with 2-part lower frame
cover) ® page 45
•
For Wall Mounting (with 1-part lower frame
cover) ® page 48
•
For Mounting on a Stand (Sold Separately)
® page 52
7
Approx. 100 mm (3
/
in.)
8
Approx.
100 mm (3
2
5
3
Measure
7
/
in.)
8