Sony PLAYSTATION SCPH-103 Manual page 16

16
Enjoying SoundScope (continued)
B
Additional operations
To change the size of the image
Press the directional buttons (up or down) while holding down the ✕ button.
To change and save the settings
1 During playback, press the R1 button while holding down the ✕ button.
A round mark flashes on the lower right of the screen.
2
Operate the controller.
While the round mark is displayed, any changes you make to the
SoundScope operation with the controller are saved.
3 When you are finished, press the R1 button while holding down the ✕
button.
The round mark disappears and the procedure is completed.
Note
Do not unplug the controller during these procedures.
To switch to saved settings
1 During playback, press the L1 button while holding down the ✕ button.
A round mark appears on the lower left of the screen, and the
SoundScope image is transformed by the saved operation.
2 Press the L1 button while holding down the ✕ button.
The round mark disappears and the procedure is completed.
Tip
Your saved setting will be lost when you turn off the PlayStation
keep the data, you can save and load it using a memory card with one memory block.
To save the saved operation on a Memory Card
Press the R2 button while holding down the ✕ button.
A round mark appears on the upper right of the screen.
Note
You can store only one custom SoundScope operation setting. If the data already exists, it
will be erased.
To load the data onto a Memory Card
Press the L2 button while holding down the ✕ button.
A round mark appears on the upper left of the screen. To use the loaded
data, follow the procedure above.
™
(PS one ). If you want to
®