Cannondale Kinneto E-Series Owners Manul page 40

User's manual
UM-70H0A-001-00
Lights
Symptom
The front light or the tail
light does not illuminate
even when the switch is
pressed.
Cycle computer
Symptom
The cycle computer display
does not appear even when
the power switch is pressed.
The gear position is not
displayed.
Can the beep be turned off.
Can the backlight be turned
off.
The setting menu cannot be
launched while riding the
bicycle.
Cause / Possibility
The E-tube Project settings may be wrong.
Cause / Possibility
The amount of battery charge may be
insufficient.
Is the power turned on?
Is the cycle computer correctly installed to
the bracket?
Is the electric wire connector correctly
installed?
The gear position is only displayed when
the power gear shifting unit is installed.
The product is designed so that if it detects
that the bicycle is being ridden, the Setting
menu cannot be launched. This is not a sign
of an abnormality.
39
E6000 Series
Remedy
Contact the place of purchase.
Remedy
Recharge the battery, and then turn the
power on once more.
Hold down the power switch to turn on the
power.
Install the cycle computer correctly while
referring to "Installing and removing the
cycle computer".
Check to see if the connector of the electric
wire connecting the motor unit to drive
unit is not disconnected. If you are not
sure, contact the place of purchase.
Check if the electric wire connector is
disconnected. If you are not sure, contact
the place of purchase.
Change the setting.
Refer to "Beep setting (Beep)".
Change the setting.
Refer to "Backlight setting (Backlight)".
Stop the bicycle and then make the
settings.
English