Part Names - Sanyo VCC-9300 Instruction Manual

PART NAMES

1
ON
2
1 2
1
System control setting switches (See p4)
Sets baud rate and sets RS485 or coaxial control.
•
Baud rate setting
Initial setting is 19200bps.
•
RS485 or coaxial control setting
Initial setting is coaxial control.
ON
1 2 3
Baud rate (bps)
2400 OFF OFF
4800 OFF ON
9600 ON OFF
19200 ON ON
2
Address setting switches (See p4)
The address of the camera set here is needed for operating the
camera through a system controller. In addition, when the
camera is connected to the system, be sure to set the terminate
setting to ON when the camera is in the last connected position.
•
Address setting (See p45)
Address values can be between 0 and 127.
Initial setting is for all switches OFF.
•
Terminate setting
Initial setting is ON.
ON
1 2 3 4
Address setting
3
Power supply unit removal lever
This lever is be used to remove the power supply from the
camera unit when switch settings need to be made.
(See p4)
4
Power supply unit
5
Camera unit
6
Lens
7
Dome cover
8
Power supply cable (AC 24 V, 60 Hz)
9
Video output connector (BNC)
English
ON
1 2 3 4
3 4 5 6 7 8
7
4
Coaxial control ON
RS485 OFF
5 6 7 8
Terminate setting
3
4
5
H
6
F
Alarm input connector (10 pin)
Use for functions such as intruder detection. Connect the
supplied alarm input expansion connector to this connector and
install the alarm detection switch on the cable side.
1 Alarm input 1
2 Alarm input 2
3 Alarm input 3
4 Alarm input 4
5 GND
G
Alarm output connector (5 pin, white)
Use for controlling peripheral equipment or supplying power to
sensors and other devices. Connect the supplied alarm output
expansion connector to this connector and use to establish
output to the cable side of the connection.
1 Alarm output 1
2 Alarm output 2
3 GND
* Open collector output, drive capacity up to 18 V, 50 mA.
H
Camera control connector (5 pin, black)
Connect this line when controlling the camera by RS485.
Connect the supplied camera control expansion connector to
this connector and connect peripheral equipment such as a
system controller to the cable.
1 A (+)
2 B (–)
3 A (+)
– 3 –
8
9
F
G
6 Alarm input 5
7 Alarm input 6
8 Alarm input 7
9 Alarm input 8
10 GND
4 N. C
5 GND
4 B (–)
5 GND