Library; Learn - NAD T175 Owner's Manual

OPERATION
USING THE HTRC 1 REMOTE CONTROL
MODE: The following backlight modes are available:
• Off: The backlight will never come ON.
• Sense: The backlight will only come ON if the light sensor detects low
light conditions. See also"SENSE LEVEL" discussion below.
• On: The backlight will come ON any time a key is pressed.
SENSE LEVEL (Sen Lvl): The point where the backlight comes ON in a
darkened room. To set this level, go to a dim area where you think the
backlight should be activated given such a dark environment condition.
Then, press [ENTER] at "B Light – Sen Lvl" menu. The display will show the
current sensitivity level. An example is below
If such sensitivity level is alright with you, press [ENTER].
Select "YES" to complete the setting of the sensitivity level.

LIBRARY

The HTRC 1 can store a different library of default NAD codes for each of
its DEVICE SELECTOR "pages. " If the original default library does not control
your NAD CD player, DVD player, or other component, follow the procedure
below to change the library code. Please refer as well to the table below for
a list of uploaded NAD Library Codes.
Example: Load NAD DVD Player T 585 library codes to HTRC 1's "DVD"
device.
1 Press [DVD] in the DEVICE SELECTOR page.
2 Press and hold [TUNER (10+/SETUP)] and [ENTER] buttons. Use [
scroll to "Library".
3 Press [ENTER].

4 The library code for NAD T585 is "600". Use [
[ENTER].
5 Use [
] to select between "No" (desired library code is not
uploaded) and "Yes" (desired library code is uploaded and saved to the
applicable device page.
NOTE
Instead of scrolling through the library list, you can also key-in directly
the library code based on the list of Library Codes below.
NAD PRODUCT
LIBRARY CODE
DESCRIPTION
Receiver/Processor
100
(Discrete ON/OFF)
Receiver/Processor
101
(Toggle ON/OFF)
102
103
Second Zone
104
Commands
105
106
107
108
109
Stereo Receiver/
110
Amplifier
111 Stereo Second Zone
112 Txx5 Series
200 CD Player
201 CD Player (old)
202 5170, 5240, 5340
203
204
205
300

LEARN

This function allows you to learn IR commands from another remote.
Example: Learning "MENU" function from a TV remote control into the
MENU button of HTRC 1's TV device.
Begin by positioning the HTRC 1 "nose-to-nose" with the source remote so
] to that the two devices' infrared windows are about 2 inches apart.
1 Press [TV] in the DEVICE SELECTOR page.
2 Press and hold [TUNER (10+/SETUP)] and [ENTER] buttons. Use [
scroll to "Learn".
] to toggle to "600". Press
NAD PRODUCT
LIBRARY CODE
DESCRIPTION
301 L75, L76 Tuner
302 L70 Tuner
S170 303 L53 Tuner
L75 304 L73 Tuner
305
L70 306
L76 307 Txx5 Series Tuner
118 400 Tape Deck B
L53 401 TAPE Deck A
L73 500 TV 280
501
502
503 PMR45
T535, T562, T585,
600
601 T550, L55
T512, T531, T532,
602
T571, T572
5325 603 L70, L73 DVD
5060 604
T513, T514, T515,
M5 605
T524, T533, T534
Tuner 606 L53 DVD
C425
C445
MR13
MR20
M55
L56
] to