Kit Contents - Parrot 3200 LS-COLOR User Manual

INTRODUCTION
The Bluetooth® technology enables voice and data communications
via a short-distance radio link. It allows several electronic devices to
communicate with each other, particularly telephones and hands-free
kits.
Parrot is drawing on its long years of experience in signal processing
and voice recognition technology to introduce a hands-free kit offering
superior audio quality during calls.
Thank you for buying a Parrot hands-free kit. With the Parrot 3200 LS-Color,
you will be able to make telephone calls from your car while keeping your
hands on the wheel.
With its colour interface and customisable wallpaper, the Parrot 3200 LS-
Color is the most user-friendly hands-free kit. It acts as a real extension of your
mobile phone. We hope that the kit will give you complete satisfaction.

KIT CONTENTS

Colour LCD screen
n
Installation cable
n
Electronic control unit
n
Directions for use
n
Fitting accessories
n
Microphone
n
FITTING
First of all, choose the place for the colour screen inside your vehicle.
We would advise you to fit it in the centre of the dashboard or near you.

Make sure that you can view the screen at a good angle and that it does not
obstruct your view of the road. Once the hands-free kit is fully installed and
switched on, you can adjust the screen's brightness.
There are two places where you can choose to fit the microphone connec- -
tion: either directly at the side of the screen or on the cable connected to the
bottom of the screen. Place the microphone to the left of the rear-view mirror
to ensure optimum audio quality.
The installation cable is equipped with ISO connectors and a line-out jack for
connecting directly to your amplifier, if applicable.
Car stereo with line-in jacks:
Preferably use this type of connection by connecting the brown and white
wires (or red and black), along with the yellow mute wire to the back of your
car stereo.
Car stereo with ISO connectors:
Disconnect the car stereo's audio and power leads. Join the female connec- -
tors of the kit's cable to the car stereo. Join the vehicle's audio and power
supply cables to the male connectors. If the car stereo features a mute jack,
connect the yellow wire of the kit's cable to one of the "mute-in" jacks (1,
2 or 3).
Car stereo without ISO connectors:
You must purchase an ISO adapter cable.
Fitting the kit's cable:
. The red wire of the kit's cable must be connected to the constant 12V
supply,
the orange wire to the ignition 12V and the black wire to earth.
. Check the wiring diagram of the car stereo's ISO lead.
On some vehicles, the red and orange wires may need to be reversed.
This can easily be done by reversing the two fuse holders.
. Do not connect the orange wire to the constant 12V supply, as you could
run down the vehicle's battery.
Checking the installation:
. If your 3200 LS-Color is correctly fitted, you should see the message
"Goodbye" on the screen when you switch off your car's ignition.
Otherwise, the ignition 12V and the constant 12V supply have been reversed.
In this case, reverse the two fuse holders on the kit's power supply lead.