Carpet Height Adjustment; Maintenance; Edge Cleaning; Power Cord - Hoover C1633 Operating, And Servicing Instructions

1. HOW TO USE

Carpet Height Adjustment

It is necessary to raise and lower the nozzle for various carpet pile heights.
For best results, the lever is conveniently adjusted by hand.
Select the adjustment for the carpet pile height according to the chart below.
Low Normal
For glue-down, short pile For carpet with normal
and indoor-outdoor type pile height and for
carpet. removing loose dirt from
hard surface floors.
Note: If the cleaner is difficult to push, move adjustment lever to next higher setting. This will decrease
the belt load and pushing effort.

Edge Cleaning

A passageway on the cleaner bottom plate improves the cleaning of carpet near baseboards and solid
furniture. Slowly guide either side of cleaner along edge of carpet.

2. MAINTENANCE

Disconnect cleaner from electrical outlet before attempting to service it in any manner.

Power Cord

To reduce twisting of the power cord, start at the cleaner handle end of the cord and coil before storing
on storage hook.
The Dirt Cup
The dirt picked up by the cleaner is deposited into the dirt cup.
When empty, the cup can be cleaned with a damp cloth or rinsed with water.
Be sure cup is dry before reusing.
When to Empty
Frequently check the dirt level in the dirt cup. It is recommended that you empty the cup when the dirt
level reaches the "Full Line" on back of cup. If more dirt is allowed to accumulate, your cleaner may not
operate effectively and spillage may occur when cup is removed.
Peak performance of your cleaner can be maintained by turning cleaner OFF, unhooking bag spring,
shaking the bag, and emptying the dirt cup frequently before it becomes full.
How to Empty
Place handle in operating
2.1
position and unhook spring
from handle.
While holding bag closure
clip, shake bag vigorously
to release dirt accumulated
in bag.
Re-hook spring and place handle in upright position.
Allow a few seconds for dirt to settle into cup.
High Highest
For carpet with normal For carpet with very
pile height but thicker high pile height and
density. thicker density.
While supporting bottom
2.2
of cup, release the two
latches by pulling them
outward as shown.
Remove cup and empty it.
5