Main Menu - Ricoh FT9101 Field Service Manual

1 July 1994
7. TABLE OF SERVICE TOOLS
The service tools can be accessed by entering "99900" using key pad. The access number can be
changed by service tool [1-02].
CAUTION
The data for the service tools will be cleared if the main
control board is replaced. Write down the set data and use it
in that case. The data in service tools 3-01 to 3-07 must be
cleared in order to reset RAM on the main control board and
start up the use of these modes.

7.1 Main Menu

The service tools have six items as shown in the main menu above.
7.2 System Set-up
Item
1-01 Key operator access code
Description
Change the user tool access number.
* This number is used to access the user
tools or to cancel the weekly timer ON
mode temporarily (the machine can be
used based on the auto off time set in
the service tool [2-13] during the weekly
timer turning off the machine.)
* Set the lower two figures of
three-figure code number beginning with
0. The first 0 cannot be changed.
Initial setting: 000
7-1
Setting Method
Press [1-01] of system set-up menu.
⇓
Input one or two-figure value from the
key pad. (The third figure and onward
are ineffective.)
⇓
Press the Enter [#] key.
* If only one figure is input, the code
number is 00x.
* Use the Clear/Stop key to change the
entered number.
* When the Enter [#] key is not pressed,
previous data is effective.
Main Menu