Panasonic KX-TG1411 Operating Instructions Manual page 20

TG1411_1412AL(e).book Page 20 Monday, December 14, 2009 4:28 PM
Useful Information
Problem Cause/solution
I fully charged the L Clean the battery ends (S, T) and the
batteries, but the charge contacts with a dry cloth, and
operating time seems to charge again.
be shorter.
Caller information is not L You must subscribe to a Caller ID
displayed. service. Contact your service provider/
telephone company for details.
L If your unit is connected to any
additional telephone equipment,
remove and plug the unit directly into
the wall socket.
L If you use a DSL/ADSL service, we
recommend connecting a filter (contact
your DSL/ADSL service provider) to the
telephone line between the base unit
and the telephone line socket. Contact
your DSL/ADSL provider for details.
L Other telephone equipment may be
interfering with this unit. Disconnect the
other equipment and try again.
Caller information is slow L Depending on your service provider/
to display. telephone company, the unit may
display the caller's information at 2nd
ring or later.
L Move closer to the base unit.
I cannot remember the L Change the PIN using the instructions
PIN. on page 21.
20
Liquid damage
Problem Cause/solution
Liquid or other form of L Disconnect the AC adaptor and
moisture has entered the telephone line cord from the base unit.
handset/base unit. Remove the batteries from the handset
and leave to dry for at least 3 days.
After the handset/base unit are
completely dry, reconnect the AC
adaptor and telephone line cord. Insert
the batteries and charge fully before
use. If the unit does not work properly,
contact an authorised service centre.
Caution:
L To avoid permanent damage, do not use a microwave oven to speed up
the drying process.
Registering the handset to the base unit
1
{j/OK}
2
{v}/{e}: "SETTING HS" i {>}
3
{v}/{e}: "REGISTRATION" i {>}
4
{v}/{e}: "REGISTER HS" i {>}
5
Press and hold {x} on the base unit for about 5 seconds.
L If all registered handsets start ringing, press {x} to stop, then start
again from step 1.
L The rest of the procedure must be completed within 4 minutes.
6
{v}/{e}: Select a base unit number. i {>}
7
Wait until "BS PIN" is displayed. i Enter the base unit PIN (default:
"0000"). i {>}
L If you forget your PIN, see page 21.